Interpretation of belt buckle manufacturing process. The harmful structure of high strength belt buckle is not realized by a special folding and stamping system. Special imported unknown steel materials are used. The strength, elasticity and toughness of the belt buckle are ensured.

Let's have a look

1、 Electroplating. Electroplating is every five categories. Such as buckle products are indispensable important components.

1. From the characteristics of electroplating can be divided into understanding electricity, control electricity. Low division LONGNING machine city lift joint roll electricity is used in products with low appearance requirements for five full buckle products. It electroplating out of the five products, its surface will not be very bright. There will be flower marks.

Of course, electroplating or this is also lower. Corns. Push nail, five claw button and bottom of each button are generally made by German electric. The power control is used in the products which have higher requirements on the appearance of the five full button products than the teaching. Such as the whole father ancestor noodles, small five full needle buckle, five whole chain one - for the control of electricity.

2. From the ring depth can be divided into: Limited electrical appliances without electroplating. Electroplating is to make the color thin by chemical treatment. Attached to the surface of the product. If "some" is added in the electroplating process. It will lead to the failure to comply with the national environmental protection standards for organic electrical inlay: for example, in the electroplating process + there is no waiting for "" component. It is no chopsticks electroplating. Of course, there are also requirements for raw materials for the five products of non chopsticks electroplating. If the raw material itself contains "slightly", it can not be done without chopsticks electroplating.

3. The common electroplating colors are: bronze, black, steel, red, blue, dumb, black, light fruit, chopsticks, etc.

2、 Spray paint (spray). In addition to the holes can be matched with any food collar color. And the difference in brightness is due to light. Semigloss. Sub oil. Spray the open oil, which is commonly known as spraying the frame oil. Mainly for acid proof treatment or surface protection. Wipe oil refers to the surface protruding part after oil injection.

3、 Make sure you use the matching model to button. The production of thick button is made to measure the mold, so when making the button, you can also get the amount of customized button mold. It is not recommended to use the button mold of other manufacturers, because the buttons produced by many manufacturers may be similar in appearance. But the effect is different. The buttons produced by different manufacturers are different: when making button products. We don't need the button mould that we can get from other channels.